User Manual

SECTION 7 MAINTENANCE AND SERVICING
169000 / 169040 104 Revision E
SAMPLE GREASE DECAL
7.6 LUBRICATION
CAUTION
To avoid personal injury, before servicing
header/mower conditioner or opening drive
covers, follow procedures in Section 7.1
PREPARATION FOR SERVICING.
Refer to Section 7.3.2 Recommended Fluids
and Lubricants for recommended greases.
The greasing points are marked on the machine
by decals showing a grease gun (A), and grease
interval (B) in hours of operation.
Log hours of operation and use the
"Maintenance Checklist" provided to keep a
record of scheduled maintenance. Refer to
Section 7.18 MAINTENANCE SCHEDULE.
7.6.1 Greasing Procedure
a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
d. Replace any loose or broken fittings
immediately.
e. If fitting will not
take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
7.6.2 Lubrication Points
Lubrication requirements depend on the model
of header/mower conditioner that is being
serviced.
Refer to the specified pages to identify
lubrication points for your specific model:
A30-S HEADER Pages 105–106
A30-D HEADER Pages 107–108
A40-D HEADER Pages 109–110
HAY CONDITIONER Page 111
DRIVELINES Page 112
PULL-TYPE CARRIER Page 113