Instruction Manual

72
S
UNLOADING & ASSEMBLY
INSTALL DRAPERS
NOTE: For delivery openings of 41.7” (1060
mm) and smaller, before installing draper, install
draper supports (S) at cutterbar
side of idler roller
bars using 3/8 x 3/4 carriage head bolts and flange
nuts. For larger openings, remove supports (S), if
installed.
NOTE: Right and left side drapers are different lengths. Be sure you have the drapers properly positioned.
Drapers are marked with an identification number. Always install the lower
number on the left side.
30 ' Header: Left side draper #100265 Right side draper #100266
36 ' Header: Left side draper #100267 Right side draper #100268
CONNECTION
CENTER DELIVERY
OPENING WIDTH (W)
(between rollers)
LEG TO
ROLLER EDGE
(DIM. X)
DESIGNATED APPLICATION
and COMMENTS
Row A to Row F (both drapers) 33.9" (860 mm) 22.4" (568 mm) Opening for combine models: Case 60 & 66
Series, NH-TR and CR 920/940/960
Row A to Row G (both drapers) 39.7" (1010 mm) 19.4" (493 mm) Opening for Gleaner combines
Row A to Row E (both drapers) 41.7" (1060 mm) 18.4" (468 mm) Opening for Case 77, 80 & 88 Series,
CNH AFX, NH-CR 970/980, Challenger 660
and MF 9690
Row A to Row H (both drapers) 49.6" (1260 mm) 14.4" (365 mm) Opening for Lexion 450, 460R, 470, 470R,
475, 560, 560R, 570R, 575R, 580, 580R &
585R Combines
Row J to Row D (both drapers) 53.5" (1360 mm) 12.4" (315 mm) Opening for combine models: JD STS,
CTS, 9500, 9510, NH-TX / CX, Challenger
670 and MF 9790
Row A to Row C (both drapers) 59.5" (1510 mm) 9.6" (243 mm) Opening for combine models: JD 9600,
9610, 9650 and Lexion 460, 465, 480,
480R, 485 & 485R Combines
Row A to Row B (both drapers) 65.8" (1670 mm) 6.4" (163 mm) Maximum opening for windrowing