Owner manual

Form # 147459 Issue 11/06 Web Rev_01

MAINTENANCE/SERVICE

Electrical System

LIGHTS AND BULBS (continued)

REPLACING RED TAIL LIGHT BULBS

1. Remove two screws (A). Remove plastic lens.

2. Replace bulb and reinstall plastic lens.

NOTE: Bulb trade #1157.

REPLACING AMBER LIGHT BULBS

1. Remove light (B) from rubber bezel.

2. Replace bulb and reinstall light.

NOTE: Bulb trade #1156.

IMPORTANT: For proper lighting pattern, be sure lights

are installed right side up.

REPLACING GAUGE LIGHT BULBS

1. Turn light switch and ignition key to OFF.

2. Remove six screws (three per side) from instrument

panel (A). While pulling out on top of instrument panel,

pull up until panel clears side console.

3. To replace gauge lights, twist

and pull bulb holder (D) from

back of gauge and replace bulb.

NOTE: Bulb trade #161.

RED LIGHTS

REMOVE INSTRUMENT PANEL

AMBER LIGHTS