Specifications

34
FEATURES AND BENEFITS
B SERIES SP WINDROWER
DWA Rear
Tailwheel Offset
DWA Carriage
DWA Carriage
The entire DWA carriage can be raised and
lowered with the header. A three position
switch in the cab controls the attachment. With
the switch in the right position, the draper is on,
and the DWA will raise and lower with the
header. With the switch in the middle position,
the draper is shut off, and the DWA will raise
and lower with the header. This allows the op-
erator to cut a short distance without the can-
vas running, allowing the windrow to be better
positioned at the ends of the field. With the
switch in the left position, the draper is shut off,
and the DWA will stay in the up position. This
allows the operator to lay a center swath with-
out removing the DWA from the tractor.
Installation and Removal
Along with the draper carriage, the kit includes
a hydraulic pump and drive, and all hydraulic
and electrical parts needed for installation.
Once the DWA is installed on the tractor, it can
be quickly dismounted and reinstalled. A jack
is provided for storage, and all hydraulic hoses
are quick disconnect. It will take about 15 min-
utes to dismount, and about 30 minutes to rein-
stall.
Offset Tailwheel Kit
(For use with DWA)
The offset tailwheel kit is used with the double
windrower attachment (DWA), and repositions
the right tailwheel behind the axle (instead of at
the end of the axle). Repositioning the tail-
wheel allows a wider double windrow to be
made without being run over by the tailwheel.
Wholegoods Kit - BK61112
Estimated Installation Time - 1.0 Hr.