Specifications

COMPETITIVE COMPARISONS
AHB AUGER HEADER
AUGER HEADERS CHALLENGER
®
AHB
JOHN DEERE
895
NH HS
CASE IH HDX
MACDON
922
Sizes Available (Ft)
14, 16, 18 14, 16, 18 12, 14, 16, 18 14, 16, 18
Lift Range (In)
-3 to 26 INA -4 to 27 -6 to 35
Header Drive
Hydraulic Motor Hydraulic Motor Hydraulic Motor Mechanical
# Belts in Drive System
1 3 2 8
Flotation
Hydraulic Hydraulic Springs Springs
On the Go Flotation
Adjustment
Standard Standard Optional NA
CUTTERBARS
Number of Sickles
2 2 2 2
Sickle Drive
Half Swaybar Enclosed Wobble Open Wobble Enclosed Wobble
Sickle Stroke (In)
3.0 3.0 3.0 3.0
Sickle Speed (SPM)
1840 1800 1900 1875 or 1450
Type of Sickles
Overserrated Overserrated Overserrated Overserrated
Guard Angle Range (Degree)
5 to 12 INA 6 to 12 8 to 16
Number of Skid Shoes
2 or 3 4 12’-2 others 4 2
Skid Shoe Positions
5 4 5 5
Gauge Wheels
Optional Optional Optional Optional
REELS
Number of Bats
5 (6 opt) 5 5 5 (6 opt)
Type of Drive
Belt/Chain Belt/Chain Belt/Chain Hyd Motor/Chain
Drive Protection
Belt Belt Belt Relief Valve
Diameter
42” 42” 42” 42.5”
Speed Range (rpm)
65 to 75 65 to 74 51 to 82 30 to 75
AUGERS
Number of Augers
2 2 1 1
Diameter (In)
9 Up 9, Low 11 20 24
Flighting Depth (In)
1.5 INA 5 6
Speed rpm
Upper 330 Upper 477 252 205
Lower 525 Lower 426
Type of Drive
Chain Enclosed Chain Chain Belt/Gearbox
Drive Protection
Slip Clutches None Opt. Slip Clutch None
Float Range (In)
Fixed Fixed 1.75 Fixed
CONDITIONERS
Type
Rubber on Steel Urethane NH - Rubber Steel Rolls
Steel on Steel Or Steel Case - Steel
Pressure System
Springs Springs Torsion Bar Springs
Length (In)
110 100 102 63.5
Roll Speed (rpm)
920 689 701 850
Roll Diameter (upper) (In)
8 or 7.75 10 10.4 8.7
Roll Diameter (lower) (In)
7.75 10 10.4 8.7
Type of Drive
Gearbox/U-joints Gear/Shaft Gearbox/Shaft Belt/Gearbox
Discharge Range (In)
40 – 96 40 - 100 38 – 96 90 W/Opt Fins
WEIGHTS
14’ Header & Conditioner (Lb)
3850 4223 3680 3649
16’ Header & Conditioner (Lb)
4100 4512 4035 3942
18’ Header & Conditioner (Lb)
4400 4892 4430 4241
NA - Not Available
INA - Information Not Available
Every attempt has been made to ensure the accuracy, but AGCO Challenger
®
assumes no responsibility for authenticity o
f
data. Data presented is obtained from various sources, including manufacturers publications.
Challenger Sales Engineering, August, 2004
101