Owner manual

Form # 147069 Issue 09/06

ASSEMBLY

Preparing the Adapter (cont’d.)

5. Install pump in storage position at slot in right

hand float spring support and secure with lynch

pin at (L).

CAUTION: Wear gloves when handling

pump.

CHECK DECK DEFLECTOR POSITION

NOTE: Side deflectors (A) are factory set for an opening width (distance between deflectors (A), to correspond

to the feeder house opening for a specific model of combine, according to the following chart.

The rear vertical edge of deflectors (A) should just fit inside feeder house opening. If factory setting is not

correct for your model of combine, loosen bolts (C) (five per side) and adjust rear of deflector to suit feeder

house opening.

* Measured at height of bracket (D).

COMBINE MAKE & MODEL

REAR

DEFLECTORS

OPENING WIDTH*

Case 60 & 66 Series 36.6” (930 mm)

Case 77, 80 & 88 Series 46.5” (1180 mm)

Case AFX 49.2” (1250 mm)

JD 50 Series (except 9650) & Contour

Master (9500, 9510, CTS & CTS II)

55.9” (1420 mm)

JD 9600, 9610, 9650 59” (1500 mm)

New Holland CR 920/940/960 36.6” (930 mm)

New Holland CR 970/980 49.2” (1250 mm)

New Holland CX 59” (1500 mm)

Lexion 450, 460R, 470, 470R, 475, 560,

560R, 570R, 575R, 580 & 580R

49.2” (1250 mm)

Lexion 460, 465, 480, 480R, 485, 485R &

590R

59” (1500 mm)

Gleaner 39.4” (1000 mm)

Challenger 660, Massey Ferguson 9690 44.1” (1120 mm)

Challenger 670, Massey Ferguson 9790 55.1” (1400 mm)

STORE PUMP ON ADAPTER FRAME

SIDE DEFLECTORS