User Manual

Form # 46290 Issue 09/05

106

UNLOADING & ASSEMBLY

PREPARE HEADER FOR WINDROWER OR COMBINE: 21' to 36'

See the Assembly section of your Windrower Tractor or Combine Adapter Operator's Manual for instruction

related specifically to preparing the Model 972 Header for a particular power unit. To convert a header from

windrower to combine configuration or vice versa, order kit as listed on page 96 and see Instruction

46532.

Moving Draper Drive Motors:

See “Draper Drive Motor Locations” on page 69 of Operator’s Manual to

determine where motors are best positioned for a particular application.

Hydraulic Requirements when Moving Draper Drive Motors:

1. Moving motors inboard on 21’ & 25’ headers: No additional hydraulic components required unless

the widest center opening is desired (greater than 54.5”). In this case, order:

PART NO. DESCRIPTION QTY.

50103 FITTING - 45º elbow, 5/8 tube male x 7/8 O-ring male 4

N/A FITTING - 45º elbow, 5/8 tube male x 5/8 tube swivel female 4

• Replace fittings at motors with one each of above elbows.

2. Moving motors inboard/outboard on 30’ header (hydraulic or manual shift): No additional

hydraulic components required. Assemble per illustration on page 108.

3. Moving motors inboard on 36’ manual shift header: Requires the following hydraulic components:

PART NO. DESCRIPTION QTY.

37134 HOSE – ½” ID, 5/8 tube female swivel (both ends), 5200 mm long 1

50103 FITTING - 45º elbow, 5/8 tube male x 7/8 O-ring male 2

N/A FITTING - 45º elbow, 5/8 tube male x 5/8 tube swivel female 2

• Replace both steel lines with above hose and plumb as shown in Parts Catalog. Install elbows on

L/H motor to clear leg.

4. Moving motors outboard on 36’ manual shift header: Requires the following hydraulic

components:

PART NO. DESCRIPTION QTY.

102257 HOSE – 1/2” ID, 5/8 tube male x 7/8 O-ring, 940 mm long 1

40678 HOSE – ½” ID, 5/8 tube male x 5/8 tube female swivel, 600 mm lg. 1

101939

HOSE – 1/2” ID, 5/8 tube 45° female x 5/8 tube male, 1250 mm lg.

• Attach 940 mm hose to upper port on L/H motor.

• Attach 600 mm hose to lower port on L/H motor.

• Attach 1250 mm hose to upper port on R/H motor.