Owner's manual

10
SPECIFICATIONS
AUGER
12 FT. 14 FT. 16 FT.
Drive Type Chain final drive
Overload Protection Hydraulic motor
Auger Type 20 in. (508 mm) diameter
variable pitch, center feed
Auger Speed 245 RPM *
CONDITIONER ROLLS
Drive Type Drivelines from enclosed oil bath chain drive
Roll Type Helical intermeshing steel “V” bars
Roll Diameter 8.75 in. (222 mm)
Roll Length 93 in. (2360 mm)
Roll Speed 827 RPM *
WHEELS
Tread Width 119 in. (3030 mm) 143 in. (3640 mm) 143 in. (3640 mm)
Tires 31 x 13.5 - 15 NHS 8 ply Terra-Rib
Tire Pressure 30 psi (207 kPa)
MATERIAL DISCHARGE
Minimum Width 30 in. (760 mm)
Maximum Width 92 in. (2346 mm)
Rear Fluffing Shield Adjustable
OPERATING SPEED
Recommended Field Speed 5 mph (8 km/h)
Recommended Transport Speed 20 mph (30 km/h)
TRACTOR REQUIREMENTS
Minimum Power 60 hp (45 kw) 75 hp (56 kw) 90 hp (68 kw)
Drawbar Capacity Must Exceed 1300 lbs. (5785 N) 1030 lbs. (4580 N) 1100 lbs. (4895 N)
PTO 540 or 1000 RPM - ASAE standard location
Hydraulic Capacity 1750 psi (12000 kPa), two hydraulic circuits
* All speeds are in no-load condition at rated tractor RPM.
(SPECIFICATIONS AND DESIGN ARE SUBJECT TO CHANGE WITHOUT NOTICE OR OBLIGATION TO
REVISE UNITS PREVIOUSLY SOLD.)