Owner's manual

16
TROUBLESHOOTING
SYMPTOM PROBLEM SOLUTION REF.
CROP LOSS AT CUTTERBAR
Does not pick-up down crop. Cutterbar too high. Lower cutterbar. *
Header angle too flat. Steepen header angle. *
Reel too high. Lower reel. *
Reel too far back. Move reel forward. *
Ground speed too fast
for reel speed.
Reduce ground speed or
increase reel speed.
*
*
Reel fingers not lifting
crop sufficiently.
Move cam arms to pos'n. Y
to increase finger pitch
aggressiveness.
14
Install lifter guards. **
Heads shattering or
breaking off.
Reel speed too fast. Reduce reel speed. *
Reel too low. Raise reel. *
Ground speed too fast. Reduce ground speed. *
Crop too ripe. Operate at night when
humidity is higher.
---
Cut grain falling ahead of
cutterbar.
Ground speed too slow. Increase ground speed. *
Reel speed too slow Increase reel speed. *
Reel too high. Lower reel. *
Cutterbar too high. Lower cutterbar. *
Reel too far forward. Move reel back on support
arms.
*
Worn or broken sickle
components.
Replace. *
Strips of uncut material. Crowding uncut crop. Allow enough room for crop
to be fed to cutterbar.
---
Broken sickle sections. Replace. *
* See your Header or Power Unit Operator's Manual.
** See your dealer.