User's Manual

Getting Started
Your Cyborg requires a source of Compressed air to be installed before use. The
best air system to use with your Cyborg is the Conquest air system. However,
thanks to the 04 Gladiator inline regulator, your Cyborg can accept air input from
any air system supplying 400-900psi of compressed air (DO NOT USE CO2).
Mounting an air system
Two mounting holes are provided on the base of the Cyborg grip frame for the
purpose of attatching your air system. Please see your air system users manual
for details on how to attatch your air system to these mounting points.
Connecting the gas
Now that your air system is mounted, you will need to connect the gas to the
base of the Gladiator inline regulator. This is best achieved using MacLine (if you
are using a air system output of 400-700psi) or braided hose (700psi+).
Your Cyborg comes from the factory with a MacLine tting installed in the Gladi-
ator. If you intend to use MacLine, then you can plumb your gun by pushing the
MacLine from your air system into the tting at the bottom of your Gladiator.
Your Cyborg is now ready to use. Screw the barrel into the Cyborg and carefully
push a paintball hopper into the feed neck. Your Cyborg is now ready to operate.
Never operate your Cyborg without eye, ear, mouth and neck protection for
yourself and anybody within range.
If you need to change the tting in the bottom of your Gladiator, please follow the
instructions below.
Unscrew the bottom cap from your Gladiator (by hand). Use a wrench to hold the
Gladiator bottom cap in place as you change the air tting (as shown below). Do
not over tighten the air tting, and use a snug wrench on the Gladiator to prevent
scratching. Now screw the Gladiator bottom cap back into the inline regulator.
4
13
Accessories
Use genuine MacDev accessories or factory approved aftermarket upgrades
for best results. For the latest list of approved aftermarket products visit
www.macdev.net
Rebuild Kit
The Cyborg rebuild kit contains all the most important parts of your Cyborg. This
kit is good for peace of mind, especially when entering an important tournament.
Conquest Air/Nitro System
The Conquest air/nitro system is the highest quality compressed air delivery
system available. The Conquest will deliver high volume, clean consistent air
to your Cyborg in a lightweight compact unit - the ultimate accessory to your
Cyborg.
MatchStik Kit
Your Cyborg was supplied bundled with a 2-piece MatchStik barrel. Own the full
7 piece kit to allow good paint to barrel match with the barrel designed for your
Cyborg.
MacLine Kit
The Macline kit includes 3 ttings (1 straight, 1 xed elbow and 1 swivel elbow)
as well as 1” of hose to ensure easy plumbing to any popular marker.
Ram Gauge
Check your LPR precisely for creep and recharge problems. Takes the guess-
work out of tuning.