Manual

USING YOUR MARKER
To get the most out of your marker, make sure that you follow the instrucons in this secon to ensure that the
marker is adjusted correctly.
Adjusng the velocity
The velocity of your marker is adjusted via an adjustment screw on the boom your inline regulator. To increase
velocity, use a 1/8” allen key to turn the adjustment screw an clockwise. Always adjust your velocity gently and use
a chronograph.
Adjusng the trigger
Your trigger has three adjustment screws, they are located in the front face of the trigger in the following order from
top to boom:
- Pull tension
- Switch actuaon point
- Pull length
You can easily adjust these three screws to personalise the feel of your trigger.
Using a loader with your marker
Your marker can operate using any commercially available loader. The soware and beam sensor will compensate for
the speed of the hopper, ensuring that the marker res as quickly as the loader allows.
Installing a loader onto your marker
Open the cam lever as shown. This should allow your loader neck to t into the feed tube as shown. If your loader
does not t into the feed tube, then you may have to loosen the cam lever - this is done by rotang the cam lever
(anclockwise). Once your loader is pushed all the way down into the feed tube, close the cam lever. If your loader is
loose, you may need to open the cam lever, and ghten it (by turning clockwise) to adjust the cam system to hold your
hopper ghtly. Only ever adjust your cam lever by one turn at a me to prevent overghtening.
Removing your loader
Open the clamp by swinging the lever on its hinge. This will loosen the loader and allow you to remove it easily. If it
does not remove easily, then it means that you have the cam lever overghtened.
DO NOT ADJUST YOUR VELOCITY ABOVE 300FPS, AND ALWAYS OBEY LOCAL LAWS AND REQUIREMENTS.
10
DO NOT OVER TIGHTEN YOUR FEED CLAMP! OVERTIGHTENING MAY RESULT IN DAMAGE TO YOUR LOADER OR
CLAMP.