Manual
QUICK SETUP
Switching your marker on and o
The on/o buon is located on a membrane pad on the rear of the frame. Push the buon with the power symbol
( ), when done correctly, your LED will display a red light (if no ball is loaded) or a green light (if a ball is loaded) and
the marker will be set with the beam sensor system on and ready to re. Turn your marker o by holding the power
buon down unl the LED goes blank.
Firing your marker
If a paintball is loaded in your marker, and the power is switched on, you may re the marker by pulling the trigger. If a
paintball is not loaded, then you need to either load one, or read the secon below on disabling the beam sensor.
Understanding the beam sensor
Your marker is equipped with a visible light sensor to determine if a paintball is correctly loaded. This system is used to
prevent accidental ball breakage due to misloaded paint-
balls. The LED indicator on the back of your grip will show
you the status of the beam sensor:
Ball loaded - green (or special colour for non semi mode)
Ball not loaded - red
Sensor error - ashing orange
Disabling the beam sensor
To disable the sensor (for dry ring), hold the scroll buon
on the membrane pad ( ) unl the LED starts ashing.
You can re-enable the beam sensor the same way.
Power buon
(for power on/o)
Scroll buon
(for eyes on/o and
programming)
Installing a preset air system
Your marker comes equipped with a high quality venng ASA (Air System Adaptor) that is designed for use with
commercially available air/nitrogen systems. To install your preset air system, unscrew the ASA cap by approxi-
mately 3 turns (do not unscrew it further, as the cap can come o completely). Once this is done, carefully screw
your air system into the ASA unl it stops.
Turning the air on and o
To pressurise your marker, screw the ASA cap down unl it stops. This will depress the pin on the end of your
air system and pressurise the marker (provided you have sucient air in your air system). To depressurise your
marker, unscrew the ASA cap unl you hear the air being vented from the cap. Your air system is now turned o
and safe to remove.
NOTE: WHEN YOU UNSCREW THE ASA CAP, YOUR MARKER MAY STORE ONE SHOT. POINT THE MARKER IN A
SAFE DIRECTION AND FIRE OFF THAT SHOT BEFORE ENTERING A SAFE AREA.
8