Manual

TROUBLESHOOTING
If you are experiencing dicules with your marker, please check this table rst to see if there is an easy soluon
listed. If at any me you are unsure about how to work on your marker, please contact a cered MacDev technician
or service centre. The best way to receive assistance online is to email MacDev support ([e-mail]).
Symptom Possible Cause Soluon
Although a fresh baery
has been ed, your
marker will not turn on
The baery has not been ed cor-
rectly
Ensure that the baery is rmly connected to
both terminals. Ensure that the posive (+)
terminal is connected to the posive terminal
on your baery.
Your marker leaks from
the solenoid
Leaking bolt switch o-ring Clean and relubricate the drivetrain with
parcular aenon to the bolt switch o-ring.
Replace if necessary.
Low air pressure Ensure that your air system is full, and that
the velocity adjustment is not set too low.
Leaking manifold o-rings Check that the two manifold o-rings are in
place between the solenoid and subplate. If
they are damaged or missing, then replace
them.
Your marker uses
excessive air
Dwell set too high Check that your Dwell seng is not over
10ms.
General leak Make certain that there are no leaks from
your ngs or air system wasng your air
supply.
Symptom Possible Cause Soluon
Your marker is
chopping paintballs
Beam sensor is turned o Always play with the beam sensor
enabled.
Beam sensor is dirty or blocked Clean the breach, bolt and sensor.
Loader is set on a force seng too
high for your paintballs
Some force fed loaders can apply enough
force to break a fragile paintball. If this is the
case, consult your loader manual to reduce
the force seng.
Detents are missing or incorrectly
installed
Replace or re-install your detents.
Ball sele delay too low Increase the ball sele delay
Your marker will not re The trigger is set up incorrectly Ensure that the trigger actuates the micro-
switch by adjusng the actuator screw.
The beam sensor is on, and there are
no paintballs loaded
Load some paintballs.
The solenoid is not plugged in Plug the solenoid into the board.
Your marker res high on
the rst shot or
inconsistently.
Creeping inline regulator Clean and lubricate the inline regulator,
ensure that the seat and piston are in good
condion.
Your marker res low on
the rst shot
Scking drivetrain Clean and relubricate the drivetrain. If you
connue to have problems:
-increase the dwell by 1-2 ms.
-increase the ABS parameter on your board.
24