User's Manual

Factory seng (Flickering blue)
This seng is only used by the MacDev Factory, do not alter this seng unless directed by a MacDev tech.
Cycle lter (Flickering red)
Your soware allows the buering of a single shot in case you pull the trigger during a cycle. This lter can be used
to reduce the me allowed to buer this shot. Adjustable from 1 (full buer) to 10 full cycle lter. Higher sengs
will reduce the amount of mechanical bounce in the marker, whilst low sengs will make the marker feel aggres-
sive and responsive.
Eye mode (Flickering white)
Your marker can ulise the beam sensor (eye) in dierent ways. This seng can be used to select which way you
would like to have the sensor used. The system can use a delayed mode, where if a ball is not detected in the
breech, a shot will be red aer a half second delay. This mode is useful if you are using a sound acvated loader,
or if you would like your gun to indicate to you when you are out of paintballs. Another opon is the forced mode.
In this mode, the marker will only re if a ball is detected. However, the user can force a shot to be red by holding
the trigger unl the marker res.
The beam sensor can also be used to test the speed of your marker by watching the bolt during dry ring. To allow
this, your marker has two test modes - test mode with full dwell, and test mode with adjusted dwell. When red in
these modes, your marker will report back to you the approximate speed achieved via the colour of the indicator
LED.
The colours are given below:
red : less than 10bps
yellow : 10-15bps
green : 15-20bps
blue : 20-25bps
white : 25+bps.
To set your eye mode, use the following register sengs:
The test mode with full dwell uses the same dwell that you are currently using with your marker, the test mode
with adjustable dwell allows you to conveniently change the test mode dwell without changing the usual operat-
ing dwell of your marker. To adjust this dwell, use the last register (Test mode dwell).
Bolt tracking delay (Flickering green)
The bolt tracking delay is a parameter used to ensure that bolt tracking is working correctly. Do not adjust this
unless you are advised by a MacDev tech.
Test mode dwell (Flickering yellow)
The test mode dwell is used to adjust the dwell used when the user selects the test mode with adjustable dwell in
the eye mode register (Described above). The user may adjust this seng from 1-30ms.
Reseng the soware
If you would like to reset your soware to the factory default sengs, gain access to the tourney buon your
board, then enter the programming mode. While in programming mode, press and hold the tourney lock buon.
Aer approximately 10 seconds, your indicator LED will ash all colours indicang a reset has been completed.
Using an RF transmier
Your stock board has provision for an RF transmier aachment. To use the RF transmier funcon, you must
plug a compable RF transmier module into the RF transmier plug (directly under the eye plugs on your
board), and it will be acvated automacally.
16
1 - delayed
2 - forced
3 - test mode with full dwell
4 - test mode with adjusted dwell