User's Manual

QUICK SETUP

Switching your marker on and o

The on/o buon is located on a membrane pad on the rear of the frame. Push the buon with the power symbol

( ), when done correctly, your LED will display a red light (if no ball is loaded) or a green light (if a ball is loaded) and

the marker will be set with the beam sensor system on and ready to re. Turn your marker o by holding the power

buon down unl the LED goes blank.

Firing your marker

If a paintball is loaded in your marker, and the power is switched on, you may re the marker by pulling the trigger. If a

paintball is not loaded, then you need to either load one, or read the secon below on disabling the beam sensor.

Understanding the beam sensor

Your marker is equipped with a visible light sensor to determine if a paintball is correctly loaded. This system is used to

prevent accidental ball breakage due to misloaded paint-

balls. The LED indicator on the back of your grip will show

you the status of the beam sensor:

Ball loaded - green (or special colour for non semi mode)

Ball not loaded - red

Sensor error - ashing orange

Disabling the beam sensor

To disable the sensor (for dry ring), hold the scroll buon

on the membrane pad ( ) unl the LED starts ashing.

You can re-enable the beam sensor the same way.

Power buon

(for power on/o)

Scroll buon

(for eyes on/o and

programming)

Installing a preset air system

Your marker comes equipped with a high quality venng ASA (Air System Adaptor) that is designed for use with

commercially available air/nitrogen systems. To install your preset air system, unscrew the ASA cap by approxi-

mately 3 turns (do not unscrew it further, as the cap can come o completely). Once this is done, carefully screw

your air system into the ASA unl it stops.

Turning the air on and o

To pressurise your marker, screw the ASA cap down unl it stops. This will depress the pin on the end of your

air system and pressurise the marker (provided you have sucient air in your air system). To depressurise your

marker, unscrew the ASA cap unl you hear the air being vented from the cap. Your air system is now turned o

and safe to remove.

NOTE: WHEN YOU UNSCREW THE ASA CAP, YOUR MARKER MAY STORE ONE SHOT. POINT THE MARKER IN A

SAFE DIRECTION AND FIRE OFF THAT SHOT BEFORE ENTERING A SAFE AREA.