User's Manual

Symptom Possible Cause Solution
Your Droid is chopping
paintballs
Beam sensor is turned off Always play with the beam sensor en-
abled
Beam sensor is dirty or blocked Clean the breach, bolt and sensor.
Loader is set on a force setting
too high for your paintballs
Some force fed loaders can apply enough
force to break a fragile paintball. If this is
the case, consult your loader manual to
reduce the force setting.
Detents are missing or incorrectly
installed
Replace or re-install your detents.
Your Droid will not re The trigger is set up incorrectly Ensure that the trigger actuates the mi-
croswitch by adjusting the actuator screw.
The beam sensor is on, and there
are no paintballs loaded
Load some paintballs
Microswitch is not working Ensure it is plugged into the correct posi-
tion, or replace.
The solenoid is not plugged in Plug the solenoid into the board.
Your Droid res high on
the rst shot or inconsis-
tently
Creeping inline regulator Clean and lubricate the inline regulator,
ensure that the seat and piston are in
good condition.
Your Droid res low on
the rst shot
Sticking drive train Clean and relubricate the drive train. If
you continue to have problems:
-increase the dwell by 1-2 ms
-increase the ABS parameter on your
board
26