User's Manual
Remove the hose from the tting in the bottom of the Gladiator reg - you do this
by pushing the collar in, whilst pulling the hose out. Once the hose is removed,
you can unscrew the Gladiator reg from your Droid. Put your Droid aside so that
you can concentrate on your Gladiator reg.
Unscrew the bottomworks from the topworks of the Gladiator reg. You should
be able to do this by hand, however, if you nd it difcult, there is an allen hex
inside the topworks and ats that you can use for grip on the bottomworks.
Use an allen key from your tool set to push the internals out of the topworks. Disassemble the internals
as shown.
Use a clean cloth to wipe the old grease from the o-rings. Use a q-tip to clean the old grease from inside
the topworks bore.
Apply a thin lm of grease to the shaft of the piston and the retainer o-rings before re-assembling the
internals. Use your nger or a q-tip to apply a thin lm of grease to the topworks bore, and apply a gener-
ous lm of grease to the piston o-ring before pushing the internals back into the Gladiator reg topworks.
Now use your clean cloth to remove any excess grease from the piston tip and clean the seat (the red
plastic part in the centre of the bottomworks. Screw the topworks and bottomworks back together. Make
certain that the Gladiator reg is screwed together rmly by hand. This will prevent it from unscrewing ac-
cidentally during play.
Re-assemble your Droid be attaching the Gladiator inline reg and hose. Push the hose in rmly until it
stops. Re-chronograph your Droid before use on the eld.
20
Contents
Know your Droid
Quick Setup
Using your Droid
Advanced Setup
Maintenance
Parts List
Troubleshooting