User's Manual

Once you have nished with the tourney lock, replace the wrap around grip and

screws before playing.

Programming the Droid Software

To program the board, turn the gun off. Hold down the trigger whilst turning the

gun on. The indicator light will turn white, continue to hold the trigger until it goes

blue (debounce register). Press the trigger once to advance to the next setting

as given below. When you have a setting you would like to change, hold the trig-

ger until the indicator light goes out. Release the trigger, and the indicator light

will ash to show the current setting. Then when it goes out, input the new setting by the trigger and wait

for the indicator light to go solid again.

LED Colour Setting Default

Blue Debounce (1/2ms increments) 10

Red Dwell (1ms increments) 12

White Fire mode 1 (semi)

Green Max ROF - only used in capped and ramp

modes

5 (15bps)

Yellow Loader delay (1/2ms increments) 2

Teal Anti Mechanical Bounce 2

Purple Anti Bolt Stick 3

Flickering Blue Ramp Start (used on ramping re modes) 5bps

Flickering Red Cycle lter 2

Contents

Know your Droid

Quick Setup

Using your Droid

Advanced Setup

Maintenance

Parts List

Troubleshooting