User's Manual

Remove the three screws that hold the wrap around grip on and peel the grip back to allow access to the
battery. Remove the old battery, and replace it with a new one. Only use high quality alkaline 9V batteries,
the best possible choice is to use a MacDev Militia PowerPack (type 6LR61).
Once your new battery is installed, ensure that all wires are in the grip cavity before replacing the wrap
around grip and xing it in place using the three screws.
Advanced Setup
About the tourney lock
The Droid board is equipped with a tourney lock system. When the tourney lock system is activated, the gun
cannot be reprogrammed on the eld - making it tournament legal.
To use the tourney lock, you must remove the three screws holding the left hand side of the wrap around grip
on your frame. On the board, there is a small copper button. Use a q-tip or similar non metallic, blunt object
to hold this down. The board will ash red/green, and then end on either red or green. This ending colour
indicates the state of the tourney lock:
Red: Tourney lock on
Green: Tourney lock off
DO NOT USE A SHARP OR METAL OBJECT ON THE TOURNEY LOCK BUTTON. DO NOT USE EX-
CESSIVE FORCE - THIS MAY CAUSE DAMAGE TO YOUR BOARD!
CAUTION! WHEN REMOVING THE BATTERY, TAKE CARE NOT TO PULL ON THE WIRES CONNECT-
ING IT TO YOUR BOARD.