User's Manual
12
5
Operating Your Cyborg
Turning the power on and off
The Cyborg on/off switch is located on the underside of the trigger guard. Slide
the switch to turn the marker on. When the Cyborg is on, the indicator LED on
the side of the grip will ignite. To turn your Cyborg off, simply slide the switch in
the opposite direction.
The LED will display the following things:
Solid red: eyes on, no ball in breech
Solid green: eyes on, ball in breech
Flashing red: eyes off
Flashing orange: eye fault
Flashing orange (on powerup): low battery
Deactivating the eye system
To dry re your gun, you will need to disable the eye system. To do this, press
and hold the trigger. After 1 second, the marker will re a single shot, after 2 sec-
onds, the LED will begin ashing red, and the eyes will be disabled. The eyes
can be re-enabled by holding the trigger again for 2 seconds.
Fine Tuning and Customising your Cyborg
Your Cyborg can be adjusted in many ways to suit your individual playing style.
You can adjust the trigger feel, sensitivity and speed.
Trigger Adjustment
There are 3 set screws around the trigger area to use for ne tuning the trigger.
The lower screw on the front of the trigger is used to adjust the length of the trig-
ger pull - screw it clockwise to reduce the trigger pull length. The second, higher
screw on the front of the trigger is used to adjust the actuation position. Screw
this screw clockwise to actuate the microswitch earlier in the trigger pull.
The nal adjustment screw is located on the top of the trigger - winding this
screw in a clockwise direction will increase the trigger pull tension.
Tourney locking the board
On the board, there is a small copper button. Use a q-tip to hold this down. The
board will ash red/green, and then end on either red or green. This ending
colour indicates the state of the tourney lock:
Red: Tourney lock on
Green: Tourney lock off
Low Pressure Regulator (LPR) Assembly
The LPR should be serviced by cleaning and relubricating the piston o-rings and
piston bore. You need not remove the assembly from the Cyborg, you can just
remove the LPR cap and, remove the piston using a pair of long nosed pliers.