MacDev 2005/06 Find us on the web at: www.macdev.net Please post warranty cards to: Australia/New Zealand MacDev PO Box 2739 Taren Point, NSW Australia, 2229 USA Paintball Kingdom 2407 Ansonville Rd Marshville NC USA 28103 Canada Hardcore Paintball 31979 Bredin Rd Kelowna BC Canada V1Y8T2 Europe OPB Arabygatan 19-21 352 46 Växjö Sweden Users Manual Owners Manual Mac Developments - Australia www.macdev.net Info@macdev.
07 Cyborg Users Manual Version 4.03 Copyright Mac Developments Pty. Ltd. 2007 All rights reserved No part of this document may be copied or reproduced in any form or by any means without the prior written consent of Mac Developments Pty. Ltd. Notice is hereby given that this manual is part of the article owned in whole by Mac Developments Pty. Ltd., known as indicated in this manual and drawings.
Accessories Introduction Use genuine MacDev accessories or factory approved aftermarket upgrades for best results. For the latest list of approved aftermarket products visit www.macdev. net Thank you for purchasing an 07 Cyborg marker. This users manual will give you a guide to setting up, tuning and maintaining your marker. Please read it thoroughly to ensure you get the best out of your Cyborg. Rebuild Kit The 07 Cyborg is a very high performance paintball marker.
Troubleshooting Getting Started Your 07 Cyborg is packaged with a venting ASA, ready to accept an industry standard screw-in compressed air system (DO NOT USE CO2). While the use of a low pressure output system (400-500psi) is recommended, a higher pressure system (up to 900psi) is also acceptable. Setting the Velocity Your 07 Cyborg has been factory set to between 275 and 300fps. Your marker should be adjusted to comply with local legal velocities.
Low Pressure Regulator (LPR) Assembly Operating Your Cyborg The LPR should be serviced by cleaning and relubricating the piston o-rings and piston bore. You need not remove the assembly from the Cyborg, you can just remove the LPR cap and, remove the piston using a pair of long nosed pliers. Turning the power on and off The Cyborg on/off switch is located on the underside of the trigger guard. Slide the switch to turn the marker on.
Programming Your Cyborg To program the board, turn the gun off. Hold down the trigger whilst turning the gun on. The indicator light will turn white, continue to hold the trigger until it goes blue (debounce register). Press the trigger once to advance to the next setting as given below. When you have a setting you would like to change, hold the trigger until the indicator light goes out. Release the trigger, and the indicator light will flash to show the current setting.
Caring for your Cyborg The Cyborg is a very low maintenance marker, however there are some things that you can do to keep it running at optimum performance. Always use Dow 33 to lubricate your Cyborg, do not use Silicone spray or oil of any kind. Bolt Maintenance The Cyborg bolt is made from a very high quality self lubricating plastic, for best results, the bolt should be kept clean and dry. During normal usage, the Cyborg bolt can become dirty.
2007 Model MacDev Cyborg Clamp Strap Clamp Screw Pull Pin Feed Tube LPR Adjuster Screw LPR Piston LPR Body Detent Detent Spring Red Valve Eye Cover (LHS) Bolt Body Eye Cover Screw Cupseal Bolt Ball LPR Cap Bolt Spring LPR Spring Cap LPR Face O-ring LPR Spring LPR Bore O-ring Cupseal Spring LPR Piston O-ring Short Grip Screw Gladiator ASA O-ring Valve Core Trigger Pin Trigger Spring Guide Switch Harness Subplate Hammer Guide Locator Gladiator Piston O-ring Bellevile Spring Pack Hammer
