User's Manual

Using a loader with your Cyborg
Your Cyborg marker can operate using any commercially available loader.
The software and beam sensor will compensate for the speed of the hopper,
ensuring that the marker res as quickly as the loader allows.
All Cyborg markers are equipped with a cam lever clamping feed tube. This
system allows the easy installation and removal of your loader. You will need
to adjust the feed tube to suit the loader that you have.
Installing a loader onto your Cyborg
Open the cam lever as shown. This should allow your loader neck to t into
the feed tube as shown. If your loader does not t into the feed tube, then
you may have to loosen the adjustment screw slightly. Once your loader is
pushed all the way down into the feed tube, close the cam lever. If your loader
is loose, you may now tighten the adjustment screw (by turning clockwise) to
tighten the loader in place.
Removing your loader
Open the clamp by swinging the lever on its hinge. This will loosen the loader and allow you to remove it
easily. If it does not remove easily, then it means that you have the clamp adjustment screw overtightened.
DO NOT OVER TIGHTEN YOUR FEED CLAMP! OVERTIGHTENING
MAY RESULT IN DAMAGE TO YOUR LOADER OR CLAMP.
Open clamp and
push loader in
Close clamp
rmly
USING YOUR CYBORG
To get the most out of your marker, make sure that you follow the instructions
in this section to ensure that the marker is adjusted correctly.
Adjusting the velocity
The velocity of the Cyborg is adjusted via an adjustment screw on the bot-
tom your inline regulator. To increase velocity, use a 1/8” allen key to turn the
adjustment screw anti clockwise. Always adjust your velocity gently and use a
chronograph.
Adjusting the trigger
Your trigger has three adjustment screws, they are located in the front face of
the trigger in the following order from top to bottom:
- Pull tension
- Switch actuation point
- Pull length
You may easily adjust these three screws to personalise the feel of your trigger.
DO NOT ADJUST YOUR VELOCITY ABOVE 300FPS, AND ALWAYS
OBEY LOCAL LAWS AND REQUIREMENTS.
CAUTION! WHEN ADJUSTING THE SWITCH ACTUATION SCREW,
MAKE CERTAIN THAT YOU DO NOT ADJUST THE SCREW IN TOO
FAR, AS THIS MAY RESULT IN DAMAGE TO YOUR MICROSWITCH.
Contents
Know your Cyborg
Quick Setup
Using your Cyborg
Advanced Setup
Maintenance
Parts List
Troubleshooting
Decrease
Velocity
Increase
Velocity
Tension
Actuation
Length
10