User's Manual
Maintaining the inline regulator
Your inline regulator (otherwise know as Gladiator reg), regulates the pressure from your air system
down to the pressure used to re your Cyborg. It is very important that your inline regulator is working
well, if not, you may experience problems with velocity uctuation or shootdown.
Before working on your Gladiator reg, make certain that the air supply is turned off (via the venting
ASA), and safely re any gas out of the gun to ensure it does not have any residual pressure.
Remove the hose from the tting in the bottom of the Gladiator reg - you do this by pushing the collar
in, whilst pulling the hose out. Once the hose is removed, you can unscrew the Gladiator reg from your
Cyborg. Put your Cyborg aside so that you can concentrate on your Gladiator reg.
Unscrew the bottomworks from the topworks of the Gladiator reg. Use an allen key from your tool set to
push the internals out of the topworks. Disassemble the internals as shown.
Use a clean cloth to wipe the old grease from the o-rings. Use a q-tip to clean the old grease from inside
the topworks bore. Apply a thin lm of grease to the shaft of the piston and the retainer o-rings before
re-assembling the internals. Use your nger or a q-tip to apply a thin lm of grease to the topworks bore,
and apply a generous lm of grease to the piston o-ring before pushing the internals back into the Gladi-
ator reg topworks.
Now use your clean cloth to remove any excess grease from the piston tip and clean the seat (the red
plastic part in the centre of the bottomworks. Screw the topworks and bottomworks back together. Make
certain that the Gladiator reg is screwed together rmly by hand. This will prevent it from unscrewing
accidentally during play.
Re-assemble your Cyborg by attaching the Gladiator inline reg and hose. Push the hose in rmly until it
stops. Re-chronograph your Cyborg before use on the eld.
22
Contents
Know your Cyborg
Quick Setup
Using your Cyborg
Advanced Setup
Maintenance
Parts List
Troubleshooting
Lube Piston
O-Ring
Lube this bore
Lube Retainer
O-Rings
Gladiator RX inline regulator cleaning