Operating instructions

42
MCS2000 by MacAllister
In more detail...
GB
IE
Technical and legal information
Safety warnings
Follow the manufacturer’s sharpening and maintenance >
instructions for the saw chain. Decreasing the depth gauge
height can lead to increased kickback.
Additional safety warnings
The product should be supplied via a residual current device >
(RCD) with a tripping current of not more than 30 mA.
Position the cord so that it will not be caught on branches and >
the like, during cutting.
It is recommended that rst-time user should, as a minimum >
practice, cutting logs on a saw-horse or cradle.
Clothing and protective equipment
Do secure long hair so that it is above shoulder level. >
Do not wear loose tting clothing or jewellery as this could be >
drawn into the engine, catch the chain or undergrowth.
Use the following safety clothing and protective equipment when >
operating the product:
Helmet with visor and neck guard - (EN397 compliant),•
Hearing protectors,•
Breathing mask,•
Gloves with approved saw protection (compliant to EN 381-•
4, EN 381-7, EN420:1, EN 388 Class 0),
Protective leggings with approved saw protection (compliant •
to EN 381-5, EN 340 Class 1),
Steel toe cap boots with approved saw protection (compliant •
to EN 345-2 Class 2),
First Aid kit in case of injury.•
Vibration and noise reduction
To reduce the impact of noise and vibration emission, limit the time
of operation, use low-vibration and low-noise operating modes as
well as wear personal protective equipment.
Take the following points into account to minimize the vibration and
noise exposure risks:
Only use the product as intended by its design and these >
instructions.
Ensure that the product is in good condition and well >
maintained.
MNL_MCS2000_DFT_GB_V06_111108.indd 42 11/8/11 5:11:22 PM