Operating instructions

MCS2000 by MacAllister
Getting started...
GB
IE
Before you start
11
Connection to the power supply
WARNING! For your safety, it is required that the plug
attached to this product is always connected to an
extension cable! The extension cable must be suitable
for outdoor use with sockets protected against water
splashing! Ensure the extension cable is of the proper
size and type for your product (≥ 1.5mm
2
)!
The extension cable must always be used with the cable
strain relief! Do not use the product without an extension
cable connected. Always use a residual current supply
(RCD) protected supply!
WARNING! Check the voltage! The voltage must comply
with the information on the rating label!
Make sure the on/off switch (15) is in its off position. >
Double the extension cable, about a foot from the end. Lead the >
loop through the hole on the rear safe guard and hook the loop
over the cable strain relief (16). Gently pull on the cord to ensure
that it is rmly attached at the handle (Fig. 14, 15).
13
16
11
Fig. 14 Fig. 15
Connect the extension cable to a suitable socket. >
Your product is now ready to be used. >
MNL_MCS2000_DFT_GB_V06_111108.indd 11 11/8/11 5:11:11 PM