User guide

1312
Unit installation and configuration/Main menuUnit installation and configuration/Main menu
Main menu
NOTE
Over the following pages, the eld locating and selection method is primarily
indicated by the “vertical button movement” and “press button” icons. However,
horizontal button movement can be used to locate and select elds, as indicated
in the General use of the unit.
1) After switching on the unit the initial display ap-
pears informing of the model, rmware version,
output frequency and information on alarms and
status:
F
Alarms:
Ì
A:0 = no alarms
Ì
A:X = alarms present
F
Status:
Ì
S:X = status correct
Ì
S:0 = status incorrect
2) Press the control button to access the main
menu.
General Settings
1) In the main menu, locate and select
GENERAL.
IP configuration
NOTE
The IP conguration affects the Ethernet interface.
NOTE
To introduce a sequence of digits in the display move the control button vertically
to change the value of the current digit and horizontally to move between digits.
1) Locate and select the option IP.
a) Locate and select the option DHCP to
activate (ON) or deactivate (OFF) dynamic
IP assigning. If this is deactivated, a static
IP must be congured.
b) Locate and select the option IP AD-
DRESS. Enter the 12-digit sequence
corresponding to the static IP address of
the unit.
c) Locate and select the option IP mASk.
Enter the 12-digit sequence corresponding
to the IP mask of the unit.
d) Locate and select the option GAtEwAy.
Enter the 12-digit sequence corresponding
to the IP direction of the LAN gateway.
Setting the time
2) Locate and select the option DAtE AND
tImE.
a) Locate and select DAtE AND tImE to
congure the time and date of the unit in
the format HH:mm yyyy-mm-DD.
b) Locate and select the option tImE zONE
to congure the reference time zone.
Selecting the country
3) Locate and select the option COuNtRy to
select the reference country.
Setting the language
4) Locate and select the option LANGuAGE to
establish the language of the menus on the
display: ESPAñOL, ENGLISH, FRANçAIS.
Blocking the LCD and joystick
5) Locate and select the option BLOCk LCD to
block access to the conguration from the LCD
display and using the control button.
a) Activate (ON) or deactivate (OFF) the
blocking option.
b) Establish a code to unlock the unit if this
option has been activated.
EN