Installation manual

IP DECT Installation Page 89
15-601085 Issue 04f (11 June 2009)IP Office
Maintenance: Phone Maintenance
Change the Phone Security PIN
1.Press Menu.
2.Enter R***76#.
3.Select Change PIN and press OK.
4.Enter the new PIN and press OK.
5.Enter the new PIN again and press OK.
Site Survey Mode
This function puts the phone in the 'site survey mode'. While in this mode the phone can also receive a call to allow
audible checking of the call quality as you move around the survey area. .
1.Press Menu.
2.Enter R***76#.
3.Select Site Survey.
4.Press OK.
5.Press Esc.
6.The phone displays the IP Base Stations and the actual field strength of the receiving signal in dBM.
· RFPI
This line shows the PARK number of the IP DECT system to which the phone is connected.
· FE
This line shows the frame errors detected by the portable part (PP = the phone) and the fixed part (FP = the
base station to which it is connected). Occasional framing errors are acceptable.
· -dBM and RPN
These two lines show the signal strength (-dBm) and the Base Station ID (RPN) of the base station providing
each signal. The Base Station ID's match those shown on the IP DECT Base Station screen when accessing the
ADMM web configuration. Note that the signal strength is in negative numbers, for example 70 is a weaker
signal than 50.
7.To leave site survey mode, switch the phone off and on again.