Installation manual
IP DECT Installation Page 74
15-601085 Issue 04f (11 June 2009)IP Office
A new phone can be added to the system by pressing New. The following pop up window appears allowing the
configuration of a new phone:
· Type
The type of phone will be automatically detected (in the case of the 3701 and 3711 phones). If the type of phone
cannot be detected, it will automatically be set to WT9620.
· If the type (WT9620, 20DT, GAP) of phone is configured before subscription and the type cannot be detected
then the configured type will be used.
· Name
This name is displayed on the handset when idle. This field is optional. If the handset is subscribed, changes to the
phone will not take effect until the phone is subscribed again.
· Number
This is the extension number to assign to the handset. The number used must conform to the dialing plan rules
required by the IP Office.
· IPEI
This is a serial number unique to the handset. For 3701 and 3711 it can be displayed as follows. For other types of
DECT handsets refer to the manufacturers instructions. Enter the number including spaces, as shown on the
phone.
· Power on the handset.
· Press Menu.
· Select System | Subscription | IPEI. Note the number displayed.
· Press Esc to return the phone to the normal standby menu.
· Authentication Code
This code is used during handset subscription. It is optional. If not set, when the Authentication Code is requested
on the handset press OK without entering a code. The Authentication Code can only be changed if the phone is not
subscribed.
A similar pop up window appears when configuring an existing phone by pressing the tool icon . The only difference is
the delete subscription checkbox. If this option is selected, the phone will be un-subscribed.
Deleting a phone can be done by pressing the trash icon. A pop up window appears and asks for confirmation. When
an IP DECT handset is deleted from ADMM web interface, the subscription should also be removed from the phone at the
same time, otherwise the phone may appear to be subscribed and have an extension number when that is not the case.










