Installation manual

IP DECT Installation Page 66

15-601085 Issue 04f (11 June 2009)IP Office

5.1.4 System | SNMP

Each base station can act as an SNMP agent. If SNMP is enabled through the ADMM, the base stations will give alarm

information to an SNMP server at the specified address and allows SNMP management software such as HP OpenView to

view the network.

The base station SNMP agent supports SNMPv1 and SNMPv2c. The agent does not support MIB-II write access, SNMPv2-

MIB read/write access, NET-SNMP-MIB read/write access, NET-SNMP-AGENT-MIB read/write access and SNMPv3. For

further details see SNMP in the Maintenance section.

1.Using a web browser login to the ADMM base station.

2.From the Home menu select System.

3.Select SNMP.

· General Settings

· Read-only community

The SNMP management software must belong to the same community in order to be able to view the IP

DECT base stations.

· System Contact

This is a general information field.

· Trap Handling

Selecting this option enables the base station to send SNMP alarms.

· Trap Community

The SNMP community name that must be matched by the SNMP server.

· Trap Host IP Address

The IP address to which base stations should send SNMP alarm events if Trap Handling is enabled.

4.Click OK.