Installation manual

IP DECT Installation Page 55
15-601085 Issue 04f (11 June 2009)IP Office
Handset Installation: IP Office User Creation
7.Select the IP DECT tab.
· The DECT Line ID should already show the ADMM base station IP address.
· Select the Message Waiting Lamp Indication Type to either On or None.
· Click OK.
8.If the extension number is new, IP Office Manager will prompt Do you wish to create an associated user?.
Select Yes.
9.Manager will automatically jump to the User entries section and show the details for the new user.
10.On the User tab, the following fields must be set:
· Name
Enter a short (less than 15 characters) name. This name must match that which will be entered for the same
extension in the ADMM configuration.
· Full Name
Enter a full name of up to 32 characters for the user. This is the main name that will be seen in most IP Office
applications and on phone displays.
· Extension
This should match the extension number of the extension just added to the IP Office configuration.
· Other settings can be adjust as normal for any IP Office user. Note that IP DECT phones do not support
button programming so entries made there will not be used.
· Click OK.
11.Repeat this process for any other IP DECT extensions that need to be added.
12.Click on to save the configuration back to the IP Office. Note that this will require the IP Office to reboot and
so will end all currently connected calls and services.