Installation manual

IP DECT Installation Page 39

15-601085 Issue 04f (11 June 2009)IP Office

Base Station Installation: Create an IP DECT Line

7.Click on the Gateway tab.

· In the Gateway IP Address field, enter the IP address of the ADMM base station.

· The remaining fields should only be changed from their defaults if required. Their functions are described

below:

· Compression Mode

Select the compression mode from the drop down list.

· Gain

This field allows the audio signal strength for calls between the IP Office and IP DECT extension to be

adjusted.

· Silence Suppression

When selected, H.323 terminals will not send data if they are silent, this is useful when optimizing data

traffic.

· Allow Direct Media Path

When disabled, the media (voice) path always passes through the IP Office Unit. When enabled, the

remote end may be told of a new IP address for the media path if, for example, the call is transferred to

a H.323 extension. Enabling this option may cause some vendors problems with changing the media path

mid call.

· Auto-Create Extension

If enabled, when an IP DECT handset is subscribed to the ADMM, extension and user entries are

automatically created in the IP Office configuration.

· Enable DHCP Support

The IP Office can be used to provide DHCP. If that is the case for a customer network, the IP Office can

also provide DHCP support for IP DECT base stations.

8.When completed click OK.

9.Click on to save the configuration back to the IP Office. Note that this will require the IP Office to reboot and so

will end all currently connected calls and services.

10.Proceed to ADMM Setup .