Installation manual

IP DECT Installation Page 33
15-601085 Issue 04f (11 June 2009)IP Office
Base Station Installation: Static Base Station Configuration
16.Click Send Configuration. The response at the bottom left should be send ok. Click Reset Configuration and
then List Configuration to confirm the settings sent to the base station.
17.If the settings are correct, the base station will request the base station software file from the TFTP server.
Depending on how long this static configuration has taken, it may be necessary to remove and then reapply power
to the base station in order to trigger the download.
18.Make a note of the base stations MAC address, the IP address assigned to it and which one of the base station IP
addresses was used for the ADMM base station.
19.Repeat this process for any other base stations, ensuring that only one base station is given the same IP address
as the ADMM IP Address.
20.Proceed to Create an IP DECT Line .
38