Specifications

OM-210 089 Page 23
5-5. Cleaning Or Replacing GA16C2 Gun Liner
Ref. ST-801 979
Tools Needed:
To Reassemble Gun:
Install contact tip.
Insert new liner.
Install collet onto liner and tighten
into gun/feeder connector using
wrench.
Cut liner off near collet so that liner
end is as close to drive rolls as pos-
sible without touching.
Install nozzle.
Remove nozzle,
contact tip, and
liner collet.
Remove liner
Gun/feeder
connector
Blow out
gun casing.
3/8 in
3/8 in
3/8 in
Turn off welding power
source/wire feeder.