Specifications

Status: Released
Version:2.2
Document: ITS-AVS Audio Visual Standards
V2.2Issued.docx
Author: Dean McFadden
Save Date: 25/08/2014
Page 35 of 63
2.16.2 Keypad Layout
AV systems provided with a push-button keypad control system shall comply with the RMIT AMX Guidelines.
Any variation to the layout must be approved by the Principal.
All programming source codes will be the property of RMIT, and must be provided to the Principal at practical
completion in both compiled and un-compiled formats.
2.16.3 Remote Management
See RMIT AMX Design Guidelines for further information
2.16.4 Web Access
All control systems must be enabled for remote web access via the AMX RMS or VNC.
2.17 Miscellaneous Technical Details
2.17.1 Operating Environment
Materials and equipment shall be capable of operating satisfactorily and as specified under the following
ambient conditions:
a) Temperature range: 0
o
C to 40
o
C
b) Humidity: up to 95%
c) Altitude: 100m
2.17.2 Mounting and locations of equipment
Locations of AV equipment shown on AV drawings are indicative only. Installation of all equipment must be
coordinated with Architect’s detail drawings.
Where no Architect is appointed, the AV Consultant will provide a set of AV layout plans and elevations as
required.
The AV Integrator must allow for movement of equipment by up to 2m without additional cost.
2.17.3 Adjust and clean
Remove debris from installation in concealed spaces. Align equipment vertically or horizontally as applicable,
and where practical, with ceiling and room features. Locate equipment symmetrically where appropriate in
relation to other features including air grilles, ceiling tiles and beams. Where possible liaise with other trades
and align with other services in close proximity. It is the AV Integrator’s responsibility to liaise with other
services and the coordination of the alignment of services and accessories in close proximity.
At final handover the equipment shall be clean of any debris or marks left from the install process.
2.17.4 System hum and interference
There shall be no visible noise or audible hum or interference in the AV systems. Where such interference
arises, it shall be removed by the AV Integrator.