User`s manual

MP-202 Telephone Adapter 58 Document #: LTRT-50605
User's Manual
¾ To place the remote party on hold when 'Flash + digits sequence'
is configured (refer to ''Configuring Dialing Parameters'' on page 39):
1. Press the 'Flash' key and then the '1' key on the phone; the phone plays a dial tone. At
this point you can initiate a second call by dialing another party's number.
2. To cancel the hold state and resume the previous phone call, press 'Flash' and then
'1'.
7.4 Performing a Call Transfer
¾ To transfer an existing call with (B) to a third party (C) when 'Flash
only' is configured (refer to ''Configuring Dialing Parameters'' on page
39):
1. During a call with party B, press 'Flash'; Party B is placed on hold and you'll hear a dial
tone.
2. Dial party C's number.
3. You can wait for C to answer or not.
4. On hook; you've transferred B to C.
¾ To transfer an existing call with (B) to a third party (C) when 'Flash
+ digits sequence' is configured (refer to ''Configuring Dialing
Parameters''
on page 39):
1. During a call with party B, press 'Flash' and then the '1' key on the phone; Party B is
placed on hold and you'll hear a dial tone.
2. Dial party C's number.
3. You can wait for C to answer or not.
4. Press the 'Flash' key and then the '2'; you've transferred B to C; a warning tone is
heard.
7.5 Establishing a 3-Way Conference
¾ To extend an existing call with party B into a 3-way conference by
bringing in party C when 'Flash only' is configured (refer to
''
Configuring Dialing Parameters'' on page 39):
1. During a call with party B, press 'Flash'; Party B is placed on hold and you'll hear a dial
tone.
2. Dial party C's number and wait until the call is established.
3. Press 'Flash' again to put B and C in a 3-way conference.
4. To end the 3-way conference call, on-hook. Alternatively, press 'Flash' again.