User guide

Replay
Replay Settings
162
Wirecast User Guide | 154809
Replay Settings
To use Replay you need to set it up the way you want it to perform. To do this select
Replay > Settings. Make your desired settings and click OK when finished.
Video Quality Set the video quality for Standard or High. Depending on what quality
you choose, an estimate of the write rate will be displayed.
Audio Check the Audio box to capture audio in the Replay you are creating. If
unchecked all audio is ignored.
Maximum Duration Sets the maximum duration of the Replay buffer. Unlimited allows
you to go all the way back to the beginning of your broadcast (no matter how long),
which will require a lot of disk space, or you can select Limited to which allows you to
choose how many minutes back into your broadcast is buffered. This option uses less
disk space. Depending on how many minutes you choose, an estimate of the disk
storage required will be displayed.
Note: If you set maximum Duration to Unlimited Replay will use disk space until all
available is used.
Replay Folder Click Browse and navigate to the location where you want to store your
Replay shots.
Default Replay Duration Specifies the default duration of a Replay clip (sets In and
Out points) when you click Create Replay Shot. For example, when the duration is set to
30 seconds (the default value) it means that the In point will be set 30 seconds before
the Replay shot was created.