User guide

Shot Editor
Shot Editor Playback
120
Wirecast User Guide | 154809
Apply To All Click this button to make the Motion Settings the same for all sources in a
shot. This is useful if you want to make all of your motion the same for all of the
elements in the shot.
Shot Editor Playback
The Playback Panel enables you to control how movies and music play in Wirecast. To
open the Playback Panel, click the Playback Panel button.
Check the Live Playback checkbox to cause your changes to be taken live in your
broadcast. The four control buttons enable you to rewind, play, pause, or fast forward.
In Point & Out Point sets the start and stop points in the media.
Select a playback speed for your shot. The audio is muted for any speed other than
normal.
Select what to do when the media is finished (loop, hold, or remove) from the drop-
down menu. Check the Begin Playing checkbox to cause the media to automatically
start playing when it becomes live. Check the Remember Position checkbox to cause
the media to remember its position when it is not live.
The vertical slider sets the audio level and the two meters display it in stereo (left and
right). Click the Master Audio Mute icon to mute the audio of your broadcast. Click it
again to un-mute it.
The Playback Panel only allows modification of parameters on media for which the
options are possible. For example, if your media has no audio, then the audio controls
are not active. Or, if your media is a still image, you are not able to set an In Point or Out
Point nor play the image.
The Playback Panel setup information is saved separately for each shot, so if a media is
used in two different shots, the media settings are different in each shot.
Playback Panel button