Instruction manual

To change the batteries:
1. Open the battery cover.
2. Making sure the battery polarity is correct,
install two AAA alkaline batteries,
Fig. 2.
3. Close the battery cover.
NOTE: It is recommended to remove the batteries
if the unit will not be used for an extended period
of time.
Setting the Date/Time
MEM
SET
MEM
SET
MEM
SET
Press the SET button
blinking Month
changing Month
confirm the entry
Fig. 1
Fig. 2
Fig. 3
8
Battery Installation/Replacement
Replace the batteries when the Low Battery
symbol appears on the display, Fig. 1, or when the
display remains blank when the POWER
Button is pressed.
Fig. 1
Fig. 2
9
1. Press the ‘Set’ Button to enter into the Time
Adjustment mode. The blinking Month will display,
Fig. 1.
2. Press the ‘MEM’ button to change.
3. Press the ‘Set’ Button to confirm entry.
4. The blinking Date,
Fig. 2, followed by Year, Hour
and Minutes will display. Repeat steps 2 and 3 to
adjust the date/time setting.
5. Your unit is now ready to take a reading, or
press the POWER button to turn the unit off,
Fig. 3.