Owner`s manual
41
Owner’s Manual
English
The 300 Control System oers you simplicity in
spa control. The backlit, Liquid Crystal Display
(LCD) displays current temperature, set water
temperature, and operating mode settings.
Each feature is actuated through the control
panel pad. Touch the appropriate button to
activate the desired function.
At start up, when power is supplied to the spa,
the controls will operate properly and safely
under the factory settings. The spa will be in
Standard mode, have a temperature setting of
100°F (38°C), and a ltration cycle duration of
1 hour. To fully utilize the unique capabilities
of the control system, it is important to know
how to set the temperature, operate the
pumps, operate the light, adjust the mode
setting, and change the ltration cycle.
Note: In event of a power outage or failure,
the 300 Series Control System may retain
settings. If settings are lost, re-program per
the instructions in this manual.
NOTE: Some spas using the 300 control
panel come with a cord connection. See
page 14 for special installation instructions
for these spas.
User’s Pads
User’s Pads are the buttons located on the
topside control panel and are used to program
various spa functions (i.e., turn on spa light, set
temperature, etc.). The following table denes
the buttons:
Pad Use
• Decrease temperature
• Increase temperature
• Switch modes
• Change ler cycle durations
• Turn internal spa light on or o
• Switch modes
• Activate therapy pump
• Set duration of lter cycles
300 CONTROL PANEL
NOTE: The look of your topside control panel design and buttons will vary according to brand.
See table below for pictures and explanation of 300 Control Panel button functions.