Owner`s manual

32
Owners Manual
English
Filtration and Ozone
On non-circ systems, Pump 1 low and the ozone generator will run during ltration. On circ
systems, the ozone will generally run with the circ pump. The system is factory-programmed
with one lter cycle that will run in the evening (assuming the time-of-day is properly set) when
energy rates are often lower. The lter time and duration are programmable. (See page 32) A
second lter cycle can be enabled as needed. At the start of each lter cycle, devices like the
blower and other pumps will run briey to purge the plumbing to maintain good water quality.
Freeze Protection
If the temperature sensors within the heater detect a low enough temperature, then the water
devices automatically activate to provide freeze protection. The water devices will run either
continuously or periodically depending on conditions.
Clean-up Cycle (optional)
When a pump or blower is turned o by a button press or after it has timed out, a clean-up cycle
runs for 30 minutes. Pump 1 on Low Speed and the ozone generator will run for the set time..
The pump and the ozone generator will run for 30 minutes or more, depending on the system.
On some systems, you can change this setting.
SPA BEHAVIOR
Be sure to set the Time-of-Day
Setting the time-of-day is important for deter-
mining ltration times and other background
features.
“Set Time will appear on the display if no time-
of-day is set in the memory.
On the Settings Screen, select the Time-of-Day
line. On the Time-of-Day screen, simply select
the Hour, Minutes, and 12/24 Hour segments.
Use the Up and Down Buttons to make
changes.
TIME OF DAY
Note: This only applies to some systems: If power is interrupted to the system, Time-of-Day will be
maintained for several days.