Owner`s manual

Owner’s Manual

English

Preparation and Filling

Fill the spa to its correct operating level (6”/15.5cm below the top of the the spa). Be sure to open

all valves and jets in the plumbing system before lling to allow as much air as possible to escape

from the plumbing and the control system during the lling process. After turning the power on

at the main power panel, the top-side panel will display a splash screen or startup screen.

Priming Mode – M019*

After the initial start-up sequence, the control will enter Priming Mode and display a Priming

Mode screen. Only pump icons appear on the priming mode screen. During the priming mode,

the heater is disabled to allow the priming process to be completed without the possibility of

energizing the heater under low-ow or no-ow conditions. Nothing comes on automatically,

but the pump(s) can be energized by selecting the “Jet” buttons. If the spa has a Circ Pump, it can

be turned on and o by pressing the “Circ Pump” button during Priming Mode.

Priming the Pumps

As soon as the Priming Mode screeen appears

on the panel, select the “Jets 1” button once to

start Pump 1 in low-speed and then again to

switch to high-speed. Also, select the other

pumps, to turn them on. The pumps should be

running in high-speed to facilitate priming. If

the pumps have not primed after 2 minutes,

and water is not owing from the jets in the

spa, do not allow the pumps to continue to run.

Turn o the pumps and repeat the process.

Note: Turning the power o and back on again

will initiate a new pump priming session.

Sometimes momentarily turning the pump o

and on will help it to prime. Do not do this

more than 5 times. If the pump(s) will not

prime, shut o the power to the spa and

call for service.

Important: A pump should not be allowed to run without priming for more than 2 minutes.

Under NO circumstances should a pump be allowed to run without priming beyond the end

of the 4-5 minute priming mode. Doing so may cause damage to the pump and cause the

system to energize the heater and go into an overheat condition.

FILL IT UP!