Owner`s manual
42
Light Bulb and LED Replacement
Ozone Purier Replacement
On the front of the Ozone Purier (optional) is the indicator
light. To verify that the Ozone Purier is working properly,
check to ensure that the indicator light is glowing while the
lter pump is running during a period when the pump has
been activated automatically.
IMPORTANT: The indicator light will not be on when any jets
button has been activated manually. The light will remain off
for 30 minutes thereafter.
NOTE: If the indicator light does not turn on during automatic
lter pump operation, contact your authorized Bullfrog Spa
dealer for service.
To replace a burned out or defective light bulb or LED,
complete the following:
Step 1: Turn off the electrical power at the breaker box.
Step 2: Remove the equipment compartment door.
Step 3: Locate the back of the light xture.
For standard light bulb replacement:
Step 4: Grasp the light bulb holder (located on the back of
the light xture) and twist counter-clockwise to release the
light from the xture.
Step 5: Remove the light bulb by pulling it straight out of the
light bulb holder.
Step 6: Replace the light bulb and reinstall the light bulb
holder.
For LED replacement:
Step 4: Insert a small standard screwdriver into the tabbed
slot (see arrow).
Step 5: Carefully pry off the back light xture cover.
Step 6: Remove the LED assembly by pulling it straight out.
Replace the LED. Reinstall the back cover of light xture.
For both lighting systems:
Step 7: Replace the equipment compartment door.
Step 8: Restore the electrical power supply.
NOTE: For alternate lighting systems, contact your authorized
Bullfrog Spa dealer.
High-Output Ozone Purier
Maintenance