Owner`s manual
40
To Rell Your Spa:
WARNING: When relling the spa, always Super Sanitize the
new water by adhering to the instructions in the Water
Chemistry section.
Step 1: To avoid air pockets in the pump(s), rell the spa with
water by placing the hose into the lter compartment
through the Weir door. Fill to the water level indication on the
faceplate of the lter assembly.
Step 2: Restore electrical power supply.
Step 3: Press any button to reset the control system.
Step 4: Reattach the equipment compartment door.
Step 5: Following instructions in Starting the Spa with
New Water.
IMPORTANT: Never ll the spa with soft water unless an
appropriate mineral supplement is immediately added. If
your water is extremely hard, it is preferable to either dilute
the water’s hardness by blending the water with water from a
water softener, or by the addition of a special water softening
chemical. For more information, see your authorized Bullfrog
Spa dealer.
NOTE: The higher the water level in the spa, the fewer spa
users it will be able to handle.
Pillow Care
1. Don’t sit on them or slide over them into the spa or they
will tear.
2. IMPORTANT: Remove the pillows when shocking the spa or
when sanitizer levels are high. Leave cover open for at least
30 minutes after shocking to ensure pillows are not affected.
3. Clean the pillow with rubbing alcohol and use a
conditioner, such as Armor All
®
monthly.
Maintenance