Owner`s manual

120V~-230V~ Heater Conversion Instructions

Step 1: Conversion must be performed by a qualied,

licensed Electrician. Hardware only.

Step 2: Disconnect from power and remove wire/cord.

Step 3: Remove wire connected to J23 and J53 completely

and discard.

Step 4: Install 230V~ power line to TB1 terminal block.

Step 5: Set dip switch 2 to “on” position.

If this unit is to be permanently-connected, connect

only to a circuit that is protected by a ground fault circuit

interrupter (GFCI).

Installation and Setup

BF03 Wiring Diagram

Ratings:

120V~/230V~, 16A/40A, 60Hz