Technical Specifications
6
STEP Final installation of back wall
Lift and place back wall (14) directly over the silicone wi-
thout sliding. Verify that the back wall (14) is plumb, shim
if needed. Then, secure the back wall to the wall studs at
top with #8 x 1¾" screws (not included) in the previously
drilled holes.
Quick tip
Hold the bottom of the back wall
with your foot when fastening in
place.
13
Apply a bead of silicone on both sides of base (13) thres-
hold at 3/8" from the base side fastening flanges.
Apply silicone on both side of the back wall (14) just
before the wall side radius.
5
⅜"
Base
Back
wall
14
min.3/16"
max.3/8"
Stud
X fastener
It is critical for the side wall
installation for there to be at least
⅛'' and no more than ⅜" between
the stud and the X fastener.
6.1
Check me!
6.3
Check me!
6.4
Check me!
Clean the shower base and apply a bead of silicone on
the threshold at 3/8" from the back fastening flange. Run
the bead of silicone the entire length of the base and 1''
on each side also.
6.2
Check me!
⅜"
⅜"
1"