User manual

Page 9 Rev. 3
Adding/Deleting CH from the memory:
1. During the normal mode, use the UP/DOWN key to select the desired channel
for programming.
2. Long press the MEM key to store up the channel as memory channel.
3. The “M” icon shows up to indicate the current channel has been saved in the
memory. No limited of memory channels.
4. Separate memory channel exists for USA, International, and Canadian
Frequency group.
5. During the normal mode, use the UP/DOWN key to select the channel to be
deleted.
6. Long press the MEM key to delete the channel from the memory.
B.11 Watch
Dual Watch
Short press DW/TriW key to activate the DUAL WATCH mode. Monitor the current
channel and Ch 16 in cycle.
Whenever, Weather Alert is activated, the Wx Alert channel will be monitored once every
4sec.
Current Channel - CH 16 – Current Channel – CH 16 – Wx Alert - Current Channel -…
Tri Watch
Long press DW/TRI key to activate the TRI WATCH mode. Monitor the Ch 16, current
channel and the 2nd Priority CH in cycle.
Note: programmed channel is the secondary priority Channel. Default secondary priority
channel is CH9.
Current Channel – CH 16 – 2nd Priority CH – Current Channel – CH 16 – 2nd Priority CH
– Current Channel - …
Note: When weather Alert is enabled, similar scheduling as the Dual-watch is used.
B.12 Backlight
Any key press will turn on the backlit (if backlit setting is ON) except the PTT key. The
backlit should be remaining on for 5 sec if no any keys pressed. The time out will be
reset if any key pressed within the time frame.