User manual

Page 8 Rev. 3
B.8 Private Channel
Short press CH/*/UIC key will enter Priveate channel. short Press Up/Down key to
change private channel. The screen will display “--”if no private channel save in
the eeprom
B.9 Scan
This is the function to scan for broadcasting channels. When available channel
detected, the receiver will stop at that channel and continue to search when that
transmission ceased.
There are 4 Scan modes available – All SCAN, Memory Scan,Priority Scan & Priority
memory Scan, Default is All Scan
1. Short press the SCAN key to activate the SCAN function.
2. When the radio in the normal mode, All Scan will be initiated. When the radio in
the All Scan mode, all channel will be scan in sequence.
3. When the radio in the memory mode, Memory Scan will be initiated. When
either All Scan or Memory Scan is active, long press the Scan key will initiate
Priority Scan.
4. Long press SCAN key during Scan operation will toggle All Scan or Memory
Scan with Priority Scan. The “P” icon (priority icon) would be lit accordingly.
The memory channel will be stated whenever signal received. Once the transmission
finished, the SCAN will automatically carry on to searching for next channel.
All Memory Scan
M1 – M2 – M3 - … M10 – M1- …
All Scan
CH1-CH2-CH3-…..-CH88-CH1
Priority Memory Scan
M1 – CH 16 – M2 – CH 16 - … CH 16 – M1 – M16 - …
(M1; M2; M3 means 1
st
, 2
nd
, 3
rd
programmed channel)
Priority All Scan
CH1-CH16-CH2-CH16-CH3-CH16-…..CH88-CH16-L1-CH16-…
(The radio only has L1 as its private channel)
B.10 MEM
Press the MEM to enter the memory mode when there is at least one channel in the
memory. The channel sequences will follow the programmed channels in the memory.
The “MEM” icon will be turned on. Short press the SCAN will start MEMORY SCAN.