User manual

Page 10 Rev. 3
B.13 Key Lock
Long press for 4 sec the Hi/Lo/Lock key will lock the keypad except the PTT key and
backlight function. A key lock icon will be displayed. Long press the Hi/Lo/Lock key
again will release the key lock function.
C. SPECIAL FUNCTION OPERATION
C.1 TX Time Out
The transmission will be automatically turn off after PTT key pressed over 5 consecutive
minutes. The Tx mode will be terminate and back to Rx mode. Once the PTT key is
released, the TX time out timer will be reset. PTT key will work back normally.
C.2 Power save Mode
Normal Mode
100ms ON, 300ms OFF
C.3 TX Indicator
When the radio is transmitting, the “TX” icon will be lit up.
D. EUROPEAN KEY OPERATION
Most of the functions in the radio are the same as the US model. These are the functions
that work differently.
D1. Programming ATIS ID
ATIS function only exists in European Model. Therefore, it only functions when the
European radio is tuned to the International Frequency Group. After ATIS ID is being
program into the radio via the keypad or the cloning software, the ATIS function will be
enabled all the time. The user cannot disable it.
To enable the customer to enter ATID ID into the radio from the keypad, the check box
next to the ATIS entry by user on the Cloning software has to be ticked.
Programming ATIS ID from the Keypad
1. Programming start with the radio turn OFF.
2. Long press Hi/Lo/Lock and turn radio ON to access the ATIS mode.
3. The front digit will indicate the digit position of the ATIS ID. The rear digit will blink
continuously. The rear digit indicates the ATIS ID. Changing the value of the rear
digit can be achieved using the “UP/DOWN” Key.
4. Press “MEM” key to confirm the selection and move to the next digit.
5. After the user complete the 9 digit ATIS ID, the user has to enter the ATIS ID the
second time to avoid invalid entry. If different ATIS ID is entered, operation will be
canceled The user has to repeat step one to initiate the ATID ID entering
sequence.