User manual

5150
DTMF Part
Click in sequence “program•Optional Features•Optional Signal•DTMF”
Step 1: Edit the Fast Call list via programming software, radio can store up to 10 groups
(0-9) last calling list in total
Step 2: Input the desired code into the corresponding list, 16 characters in maximum.
Step 3: Choose the desired DTMF decoder from available values: “Code Squelch (Picture
1) and Selective Call (Picture 2)”
Step 4: Choose the Intermediate Code if you select “Selective Call” (The first three are ID
code and the fourth are Intermediate Code)
Step 5: Choose the group code, then click [save] after finishing it, and then exit.
Picture 1 Picture 2
OPTIONAL SIGNALINGS
Optional Signalings (Programmed by software)
This transceiver supports four optional signalings (MSK, DTMF, 2-Tone, 5-Tone).
Click in sequence “program → Optional Features → Optional Signal → Common Set”, the
programming software also has three versions: simple version (Supporting MSK Signaling),
DTMF version (Supporting MSK signaling and DTMF signaling) and 5T&2T version
(Supporting MSK signaling and 2T/5T signaling). Please check the version first before
programming. If the version of programming software is different from the radio version,
you cannot program via software.
In transmitting, maybe radio cannot receive the complete signaling, because radio needs
time to switch when in power-saving state. We have to set the “Digit delay”, that’s, to send
a carrier first, let radio receive signal, then send Signaling to make sure it will be received.
The suggested time for delay time is more than 400S
Press [ ] key, LCD will display “DTMF?”, “MSK?” or “2Tone?”, Press [ ] and [ ]
keys to make call with the desired call list message. If the corresponding call list has not
been edited, the function is not available.