User manual

5756
E.g. the self ID is CCIR2, 5tone is 2A358; the ID of other radio is 44044 (group number is
0). As following picture 9:
Picture 9
Click “Save” after editing desired 5tone, and then write into the radio
Click “More” after the channel needed editing to enter setting. Select 5tone in the Optional
signal, and then select the List Num want to call, and click “ON” in the Auto Response.
You also can set the frequency and channel then press “OK” to save the information to the
radio (Picture 10)
Picture 10
Make 2-tone call with the transceiver
1)
2)
Power on, then select the channel with 2-Tone signal
Press [ ] key, LCD displays “CALL/2T?”,
then press [ ] key to transmit 2-Tone while press [ ] to
transmit a single tone/Group call. If the corresponding call list
has not been edited, it will sound “DU”.
5-Tone Part
Edit 5tone message
Click in sequence “program → Optional Features → Optional Signal → 5-Tone” to program
5-Tone ID and 5-Tone international standard group.
The group numbers 0-9 in the call list is used to edit the 5tone ID of the radio you want to
call. You can put 0-9, A, B, C, D and number (including repeated ID)
The group in the international standard are: CCIR1, CCIR2, CCITT, EEA, EIA, NATEL,
ZVEL1, ZVEL2, 9 groups in total.
Select one of them and input self ID (input in ID), and then write into the radio.